Operating Instructions,
continued
chanGinG The baG
In order to keep your Vroom Solo operating at peak performance it is necessary to perform
simple, routine maintenance to the system. The Vroom Solo is equipped with a one gallon
capacity bag and secondary filter & support (see illustration below for replacement reference).
The collection bag needs to be replaced at regular intervals based on how frequently the system
is used. To maintain vacuum power, replace the bag (part number 7797-V) when it is 2/3 to 3/4
full.
To chanGe The filTer baG:
(Replacement bag 7797-V)
Locate the Vacuum Canister. Remove the lid by placing fingers in hand-hold of lid. Now the
bag is visible. Pull the bag collar off the connector and dispose of bag. Check to be certain the
filter and filter supports are positioned correctly (see Filter and filter supports instructions below).
Open the new bag (part number 7797-V) by gently expanding the pleats on the bag. Slide the
bag collar securely onto the connector. Replace the lid. Do not operate the Vroom Solo without
the proper bag and filters installed.
filTer and filTer supporTs
(Filter Supports part number 4934/4928: Filter part number 4929)
The secondary filters and filter support are in place to insure proper airflow around the collection
bag. It is usually not necessary to replace these parts, but it is important to check that they
are located properly each time your replace the collection bag. (See illustration for proper
positioning)
NOTE: This appliance has a
THERMAL PROTECTOR built into
the motor to prevent overheating. If
motor will not operate, wait until the
motor cools, then pull power cord
plug out of receptacle– re-insert to
reset. If motor brushes or bearings
are worn out, the thermal protector
will trip off again after a short period
of time. If this happens, service for
this and any other servicing should
be performed by an authorized
dealer.
To order replacement parts (7797-V, 4934, 4928, 4928) go to www.centralvachq.com or call
H-P Products at 1-800-822-8356.
11