Operating Instructions; Assembling The Coupler - TrimmerPlus BV720r Manual Del Operador

ASSEMBLING THE COUPLER

The TrimmerPlus® system enables the use of these
optional add-ons.
Cultivator . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . GC720r
Hedge Trimmer . . . . . . . . . . . . . . . . . . . . . . . . . . HS720r
Edger . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .LE720r
Sweeper/Blower . . . . . . . . . . . . . . . . . . . . . . . . . . SB720r
Straight Shaft Trimmer . . . . . . . . . . . . . . . . . . . . . SS725r
Snow Thrower . . . . . . . . . . . . . . . . . . . . . . . . . . . ST720r
Turbo Blower . . . . . . . . . . . . . . . . . . . . . . . . . . . . TB720r
Tree Pruner . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .TP720r
WARNING:
Read and understand operator's
manual for unit to be used with this add-on
prior to operation.
Removing the add-on:
1. Turn the knob counterclockwise to loosen (Fig. 5).
2. Press and hold the release button (Fig. 5).
3. While firmly holding the upper shaft housing, pull the
snow thrower attachment out of the coupler (Fig. 6).
Installing the add-on:
WARNING: To avoid serious personal injury
and damage to the unit, shut unit off before
removing or installing add-ons.
NOTE: To make installing or removing the add-on
easier, place the unit on the ground or on a
work bench.
1. Remove the hanger from the top of the shaft housing.
2. Turn knob counterclockwise to loosen (Fig. 5).
3. While firmly holding the add-on, push it straight into
the coupler (Fig. 6).
Coupler
Release Button
Counterclockwise

OPERATING INSTRUCTIONS

Guide Recess
Clockwise
Knob
Fig. 5
NOTE: Aligning the release button with the guide recess
will help installation (Fig. 5).
Coupler
Primary Hole
Upper Shaft
Housing
Knob
3. Turn the knob clockwise to tighten (Fig. 7).
CAUTION: Lock the release button in the
primary hole (Fig. 6) and securely tighten the
knob before operating this unit.
CAUTION: The add-ons with the coupler
system are to be used in the primary hole only.
Using the wrong hole could lead to personal
injury or damage to the unit.
The blower/vacuum add-on should be installed with the
release button in the primary hole.
Check Flex Shaft Engagement Prior to Using
1. Start the unit.
2. Briefly engage and release the trigger.
3. Check that add-on is operating.
4. If the add-on is not operating, remove add-on and
repeat steps for installing the add-on.
5. Recheck operation of add-on attachment.
Release Button
Lower Shaft
Housing
Fig. 6
Knob
Fig. 7
8