CST/BERGER LASERMARK LD500 Manual De Instrucciones página 6

SPECIFICATIONS
Description
Horizontal acceptance range:
Vertical acceptance range:
On-grade dead bands
Battery
Battery Life
Auto shut-off
Operating temperature
Environment
WARRANTY
Two Year Warranty. CST/Berger, a division of Stanley Works, warrants this electronic measuring
tool against deficiencies in material and workmanship for a period of two years from the date of
purchase. Deficient products will be repaired or replaced at CST/Berger's option. Proof of
purchase is required.
This Warranty does not cover deficiencies caused by accidental damage, wear and tear, use other
than in accordance with the manufacturer's instructions or repair or alteration of this product not
authorized by CST/Berger.
Repair or replacement under this Warranty does not affect the expiry date of the Warranty. To the
extent permitted by law, CST/Berger shall not be liable under this Warranty for indirect or
consequential loss resulting from deficiencies in this product.
Agents of CST/Berger cannot change this warranty.
This Warranty may not be varied without the authorization of CST/Berger.
This warranty may provide you with additional rights that vary by state, province or nation.
I I M M P P O O R R T T A A N N T T N N O O T T E E : The customer is responsible for the correct use and care of the instrument.
Moreover he is completely responsible for checking the job along its prosecution, and therefore for
the calibration of the instrument. Calibration and care are not covered by warranty.
6 • LD500
LD500
240°
5.0 inches (12cm)
Grade rod mode:
Machine Mode-fine:
Machine mode-wide:
2X "AA"
160 hours
30 minutes
-4°F to 120°F (-20°C to 50°C)
Waterproof
For warranty and repair information, contact:
Your Local Distributor, or CST/Berger.
Subject to change without notice
3/16 inch 0.2 inches (5mm)
3/8 inch 0.4 inches (10 mm)
1 inch 1.0 inches (25mm)
G
Se
ut
M
57
Co
To
re
S
Es
in
in
N
m
se
El
(U
Ra
El
(E