Operating Instructions; Control Panel - Pleasant Hearth GLF-5002-50 Manual De Instrucciones

OPERATING INSTRUCTIONS

Read All Instructions Before Use
Check that the heater outlet grill is not covered or obstructed in anyway, and make sure the power to
the unit is switched on .
NOTE: When the heat function is used for the first time, a slight odor may be present. This is normal
and should not occur again unless the heater is not used for an extended period of time .

Control Panel

The control panel is located on the front of the fireplace.
Main Power Button:
This button supplies power to all the functions of the log set . The main power button must be in the
ON position, either from the remote or controls on the log set for the functions to work .
Heater Control Button:
This button controls the heater ON/OFF and 5 temperature modes from Low to High . When the
heater is first turned on, it will come on at the lowest temperature setting. The log set will remember
the last heat setting and in later use the heater will start at that setting, unless power to the unit has
been interrupted . Each time the temperature button is pressed, the temperature set point increases,
allowing you to adjust the ambient temperature .
Heater Locking Function:
When fireplace is ON, press the main power button for 10 seconds . The heater will be locked, and the
heater control button on the control panel as well as on the remote control will be disabled . Before the
heater is locked, the flame will flash 6 times. To unlock the heater, press the main power button for 10
seconds. Before the heater is unlocked, the flame will flash 6 time.
Flame Control Button:
This button controls the brightness of the flame effect with settings at High, Medium, and Low. When
the electric fireplace is first turned on, the flame will come on at the highest setting. The log set will
remember the last flame setting used and in later use the flame brightness will start at that setting,
unless power to the unit has been interrupted. Each time the flame button is pressed, the flame
brightness decreases. The only way to turn off the flame effect completely is to turn off the main
power button .
NOTE: After the fireplace has been operating, when the unit is turned off, the fan (not the heater) will
continue to run for about 1 minute to cool down the interior of the unit . During this time, you may feel
cool air from the blower outlet . This is normal and does not require any action . The fan will stop once
the interior cools down .
10