Replace The Wifi Camera Module; Replace The Drive Motor; Install Undercarriage&Protectors; Connect Transmitter To Drone - AKASO A31 Manual Del Usuario

REPLACE THE WIFI CAMERA MODULE

(Pic .1)
1. Take out the light module: rotate the module to remove it and disconnect the
connection wire.(Pic.1)
2. Connect the plug of wifi camera module to the drone power port.(Pic.2)
3. Aim the fuselage to install the camera, rotate the module until fasten it.(Pic.3)

REPLACE THE DRIVE MOTOR

(Pic .1)
(Pic .3)
1. Use screwdriver to unscrew the motor cover and take it down. (Pic.1)
2. Unplug the motor connection wire to remove the motor. (Pic.2)
6
(Pic .2) (Pic .3)
(Pic .2)
(Pic .4)
3. Install the replacement motor into the motor slot and connect the motor in port with
the correct polarity. (Pic.3)
4. Fasten the motor cover by screwdriver.
INSTALL UNDERCARRIAGE&PROTECTORS
(Pic .1)
1. Install the undercarriage to the bottom of drone then fasten the screws. (Pic.1)
2. Fasten the protector to each corner. (Pic.2)

CONNECT TRANSMITTER TO DRONE

Press the power switch,
the drone light flashes,
it means the power is on.
3.7V 750mAh
Li-Po battery
CAUTION Press the button once
and the indicator light
Push the left rocker to the
turns on. It means that
top , then to the lowest
the power is on.
(Pic .2)
Step 1:
Place the drone in the flat ground, insert
the Li-po battery into the drone ,turn on
the drone, don't move it until the drone
light flash from quickly to slowly, then the
transmitter can be connected to the drone.
Step 2:
Turn on the transmitter, push the left rocker
to the top, then to the lowest, the drone
light stop flash , connect successfully.
7