Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
ROTATION button on the back of the unit.
2. To focus, rotate the focus knob to desired result.
3. The angle of the projector can be adjusted by angling
the projection arm forward or backward.
LOW BATTERY INDICATION
Low battery indication is available for the home receiver
and the remote sensor. A battery life "
shown on the home receiver or remote sensor. Replace the
batteries as necessary and follow the setup procedure as
mentioned earlier in the "GETTING STARTED" section.
MOUNTING INSTRUCTIONS
Table Top -
For the home receiver, snap the base into the back of the
unit. For the remote sensor, simply pull out the integrated
stand from the back.
Wall Mount -
For the remote sensor - Set a screw into the desired
hanging location and mount.
MAINTENANCE AND CARE
INSTRUCTIONS
• Extreme temperatures, shock or areas of unusual vibration
should be avoided to prevent damage to the units.
• Clean the units using only a soft, damp cloth to wipe.
Do not use solvents, abrasives, detergents or other strong
cleaning agents. After cleaning, wipe surfaces with a dry
cloth.
• Do not submerge units in water or other liquids.
• Do not subject the units to extremely severe temperatures
- DO NOT PLACE UNITS INTO OVENS, FREEZERS or
MICROWAVE OVEN.
6
" icon will be
NOTES
• Opening the housing of either the remote sensor or the home receiver will
invalidate your warranty. Do not attempt to repair this unit. There are no
consumer serviceable parts.
• If you encounter any difficulties in setting up your wireless thermometer
system, please contact Customer Service.
• Your new RF Thermometer is built with random security code technology.
The home receiver will learn the random code of the remote sensors and
log it in as channel 1, then set the additional remote sensors as channel 2
and channel 3 if necessary. The home receiver can monitor up to 3
separate sensors. One remote sensor is included. To purchase additional
Remote Sensors (Taylor model 1439), please call 1-877 858-0065 Monday-
Friday 9am to 6pm CST or visit www.partshelf.com.
• Once a channel is registered, it will not accept any new sensors. However,
registered channels can be erased by removing the batteries in the
remote sensor or the home unit.
• When replacing batteries for the remote sensor - Remember to clear the
corresponding channel of the home receiver by removing the batteries,
and unplugging the adaptor or select the respective channel of the sensor
by pressing the CHANNEL button on the home receiver. Hold the
CHANNEL button for 3 seconds to clear the registration.
• When replacing batteries for the home receiver - Please remove the
batteries of all remote sensors. Once you have replaced the home
receiver batteries, re-install the batteries to the sensors and re-log them in
again. This will ensure that the home receiver and the remote sensors are
properly synchronized.
• Press the Tx button on the back of remote sensor to verify the RF reception.
• It is recommended to test the home receiver and the remote sensor next
to each other to ensure that both are properly synchronized.
• Keep the remote sensor out of direct sunlight and rain. Do not mount
on a metal surface.
About the Atomic Clock
The National Institute of Standard and Technology (NIST) in Fort Collins,
Colorado broadcasts the time signal (WWVB at 60kHz AM radio signal)
with an accuracy of 1 second per every 3,000 years. The signal will cover
a distance up to 2,000 miles from the source. Like a typical AM radio,
your Atomic Clock will not able to receive the WWVB signal in places
surrounded by heavy concrete or metal panels. The reception of the time
7
Publicidad
Tabla de contenido
