Tabla de contenido
Publicidad
INSTALLATION IN DETACHED HOUSES WITH 2 POINTS OF ENTRY
PROGRAMMING INSTRUCTIONS
The programming of the telephone must be carried out from the entrance panel which is configured as the main panel of the system
(with J1 jumper in place: see wiring diagram on page 8).
To program the connections bracket, it must first be made ready to receive the code. To do this follow these steps:
Connect the cord between the telephone base and the receiver. You will hear a continuous tone with the PROG switch in the ON
position.
Turn the PROG switch to the OFF position (2.1), the tone stops. Turn the switch back to the ON position (2.2).
Press the lock release button. The audio will be activated between the telephone and the main panel. The telephone is ready to
receive the code.
From the main entrance panel, make the call to the house or flat when telephone to be programmed is installed. The panel emits
a confirmation tone. The telephone has been programed.
Check the operation of the telephone (call, audio and door opening). If the telephone does not function correctly then repeat the
process from Step 2.
Note: Maximum time limit of 1 minute between Steps 2 and 3 and between 3 and 4. The system warns by means of a series of beeps
of the end of the time limit between Steps 3 and 4; repeat Step 3 to have another minute. If the time limit is exceeded the process must
be repeated from Step 2.
D I G I T A L
- PROGRAMMING STEPS -
D O O R
E N T R Y
S Y S T E M S
Publicidad
Tabla de contenido
