Alesis GuitarLink Guia Del Usuario página 5

Receiver Features
Front Panel
1. Pair Button – Press this button to
connect to the transmitter. The Pair
LED will illuminate when connected
to the transmitter.
2. Pair LED – Illuminates when the
receiver is connected with the
transmitter.
3. Power LED – Illuminates when the receiver is powered on.
4. Volume – Adjusts the volume of the signal going to the Amp Output.
5. Amp Output – Use a standard 1/4" cable (not included) to connect the GuitarLink
Wireless receiver to your amplifier.
Rear Panel
1. Battery Compartment – Insert 2 AAA batteries
here to power the receiver.
2. On/Off Switch – Slide this switch to power the
receiver on.
3. Power Input – Connect the included 5V 1A,
Center-Pin Positive power adapter here.
4. Antenna – Place the antenna in a vertical
position for best results in transmitting the wireless signal. If the wireless signal quality is
poor, change the position of the antenna.
2
1
3 4
1
1
1
5
5
2 3
4
2
3
2
3
4
4