Battery Replacement Interval
Under normal usage, alkaline batteries last
approximately four months. When the batteries
wear out, a battery mark is displayed on the
LCD. Although the remote control can still be
used when the battery mark is displayed, the
batteries should be replaced as soon as
possible. The LCD eventually starts to flash
when buttons are pressed, the remote control
will be unable to transmit signals or learn
codes.
• This remote control uses non-volatile
memory so that the learned codes and
macro programs are retained even if the
batteries are removed.
Reset the clock after replacing the batteries.
Safety Precautions for Batteries
Be sure to always observe the following
p r e c a u t i o n s t o p r e v e n t f l u i d l e a k a g e ,
overheating, fire, breakage, accidental
ingestion, and other accidents.
• If the batteries are left unused for a long
period of time, the battery fluid may leak or
the batteries may corrode.
• Do not use the batteries in the remote
control with the plus and minus polarity
reversed.
• Do not attempt to recharge, heat, or
disassemble the batteries. Do not put the
batteries in a fire.
• Do not use the remote control with old
batteries or worn-out batteries inserted.
• Do not use different types of batteries or mix
old and new batteries in the remote control.
• If the remote control is not operating
properly, replace the batteries with new
ones.
• If any of the batteries are leaking, completely
wipe up all leaked battery fluid, and then
replace the batteries with new ones.
RC1400N 01 ENG
11
Page 11
Adobe PageMaker 6.5J/PPC
03.10.6, 4:17 PM