Intended Use; Technical Data - EINHELL BT-SM 2534 Dual Manual De Instrucciones

Anleitung_BT_SM_2534_Dual_SPK7:_
GB
3. Items supplied (Fig. 1-3)
Open the packaging and take out the equipment
with care.
Remove the packaging material and any
packaging and/or transportation braces (if
available).
Check to see if all items are supplied.
Inspect the equipment and accessories for
transport damage.
If possible, please keep the packaging until the
end of the guarantee period.
IMPORTANT
The equipment and packaging material are not
toys. Do not let children play with plastic bags,
foils or small parts.
There is a danger of swallowing or suffocating!
Drag, crosscut and miter saw
Clamping device (8)
2 x workpiece support (10)
Sawdust bag (22)
Allen key (c, d)
Original operating instructions
Safety information

4. Intended use

The drag, crosscut and miter saw is designed to
crosscut wood and plastic respective of the
machine's size. The saw is not designed for cutting
firewood.
The equipment is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse. The user/operator and not the manufacturer
will be liable for any damage or injuries of any kind
caused as a result of this.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
equipment is used in commercial, trade or industrial
businesses or for equivalent purposes.
The equipment is to be operated only with suitable
saw blades. It is prohibited to use any type of cutting-
off wheel.
To use the equipment properly you must also observe
the safety information, the assembly instructions and
the operating instructions to be found in this manual.
All persons who use and service the equipment have
18
24.01.2011 8:47 Uhr Seite 18
to be acquainted with these operating instructions
and must be informed about the equipment's
potential hazards. It is also imperative to observe the
accident prevention regulations in force in your area.
The same applies for the general rules of health and
safety at work.
The manufacturer will not be liable for any changes
made to the equipment nor for any damage resulting
from such changes. Even when the equipment is
used as prescribed it is still impossible to eliminate
certain residual risk factors. The following hazards
may arise in connection with the machine's
construction and design:
Contact with the saw blade in the uncovered saw
zone.
Reaching into the running saw blade (cut
injuries).
Kick-back of workpieces and parts of workpieces.
Saw blade fracturing.
Catapulting of faulty carbide tips from the saw
blade.
Damage to hearing if ear-muffs are not used as
necessary.
Harmful emissions of wood dust when used in
closed rooms.

5. Technical data

AC motor:
Power:
Idle speed n :
0
Carbide saw blade:
Number of teeth:
Swiveling range:
Miter cut to the left:
Miter cut to the right:
Saw width at 90°:
Saw width at 45°:
Saw width at 2 x 45°
(double miter cut left):
Saw width at 2 x 45°
(double miter cut right):
Weight:
Laser class:
Wavelength of laser:
Laser output:
230 V ~ 50Hz
2100 W S1 / 2350 W S6 25%
4500 min -1
ø 250 x ø 30 x 3 mm
48
-45° / 0°/ +45°
0° to 45°
0° to 45°
340 x 75 mm
240 x 75 mm
240 x 42 mm
240 x 25 mm
approx. 16 kg
2
650 nm
≤ 1 mW