Product Installation - Key Automation SUN Serie Instrucciones Y Advertencias Para Su Instalación Y Uso

4 - PRODUCT INSTALLATION

4.1 - Installation
ù
Before proceeding with the installation, check the integrity of the
product and that all components are present in the package.
Check that the gate weight respects the limit of the table (paragraph
2.2) and dimensions of the gear motor are met (Fig. 1).
Fig.2 shows a typical installation:
- Gear motor
- Photocells
- Columns for photocells
- Flashing light with antenna
- Key switch or digital keypad
Installing the foundation box
Verify the orientation and the overall dimensions of the base plate
(S=SUN, T=TURBO), fix to ground the base-plate through 4 sturdy
screw-anchors or drown it into the concrete (Fig.3).
Plan for one or more sheathing for the passage of the power lines.
ATTENTION: The exact dimensions of the rack must be known
to allow precise calculation of the counterplate position.
Motor unlock
Release the gearmotor (Fig.4).
Take the lid off unscrewing the screw (Fig.5) and use a screwdriver
to pull up gently the sides of the cover (Fig.6).
WARNING: with motors with integrated night lights (Night Light
System) make sure not to rip off the cable that connects the
leds on the cover with the control board. In case disconnect the
white terminal. (Fig. 7).
Lay the gear motor on the base plate. Fix the 4 nuts.
It is important to lock the nuts forcefully, making sure, that the gear-
motor is steady on the ground, during the whole gate running.
If the regulating allowed by the rack is not sufficient, it is possible to
counterbalance the gearmotor high working on the four screws
(Fig.8).
The screws should be tightened again after the motor has been ope-
rated a few times.
Rack assembling
Open entirely the gate.
Put a rack element on the pinion gear and fasten it to the gate with
screw and spacing bars (Fig.9).
Move the gate manually bringing the pinion gear into line with the
last spacing bar.
Fasten the rack element for good.
For a correct positioning of the other elements and to assure their
straightness, it is necessary to employ a rack element using it as
support and reference. It is besides necessary to assure an aperture
of 2 mm between rack and pinion gear, so that the gate weight doe-
sn't rest on the gearmotor pinion gear.
Limit switch fixing
ATTENTION: The gate has to be equipped with stop locks at the
opening and closing, which prevent the gate derailment.
The stop lock position must assure that the limit switch brackets don't
collide with the pinion gear.
Haul the gate manually at the opening leaving, depending on the
gate weight, a crack from 30 to 50 mm between the main gate and
mechanical stop.
Fasten the limit switch bracket through the dowels so that the limit
switch is pressed (Fig.10).
Follow the instructions of the control panel and close the cover.
EN
11