Guided Tour - Rear Panel - Hartke GT60 PIGGYBACK Manual De Uso

Guided Tour - Rear Panel

A
A. AC POWER INLET - Use the supplied grounded AC power cord to connect your GT Series
amplifier to mains power. This cord comes supplied with the appropriate plug for your
geographic area. CAUTION: Do not use an adapter to defeat the third grounding pin on this
plug or severe electric shock may result!
B. VENT - The Vent provides vital cooling to your Model GT60. Make sure that it is kept free of
all obstructions and that cool, fresh air is accessible at all times. Also, try to ensure that the
Model GT60 is used in a dust-free environment.
SPEAKER OUTPUT – The jack is used to connect the internal driver of the combo cabinet or
C.
to the external GH 408 cabinet.
EFFECTS RETURN - Use this 1/4" unbalanced jack to return signal from a professional out-
D.
board effects processor.*
EFFECTS SEND - Use this 1/4" unbalanced jack to send signal to a professional outboard
E
effects processor.* Output level is approximately 0 dB to +4 dB and is post-EQ and post-
Volume. The signal from this output can also be used as a Direct Out for recording.
F. FOOTSWITCH jack - Connect a standard footswitch for channel selection.
* In-line effects (such as footpedals) intended for low signal levels should be placed
between your guitar and the front panel GT SERIES amplifier Input and not connected with
the rear panel Effects Loop jacks.
B
6 6
C D E F