Sony WRT-860A Manual De Instrucciones página 14

Operation
If you keep either button pressed, the channel setting will
be incremented or decremented successively.
The setting will cycle the channel from 68-01 through
69-47.
68-01 68-02
69-47
3
Once the desired channel number (or frequency) appears,
set the POWER switch to OFF to release setting mode.
The next time you turn on the power only by setting the
POWER switch to ON, the transmitter will be set to
transmit mode with the selected channel.
14
68-47
69-02 69-01
Notes
•
The unit cannot transmit in setting mode.
•
Make sure that the channel selected is the same as that
selected on the tuner used in the same system.
•
Depending on the noise or interference conditions, the
selectable channels may not necessarily all be usable. If
necessary, you can determine the usable channels by
stepping the channel selection through a number of
channels on a tuner with the transmitter set to OFF.
Those channels on which the RF indicator of the tuner
does not light are usable.
•
If there is a TV broadcasting station near by, do not use
the station's channel.
•
The unit may not operate correctly if it is turned on again
immediately after turning off the power while in setting
mode. Pause for a few seconds or more before turning on
the power again.