Porcelanosa Systempool Krion 3-WAY Serie Manual Instalación página 9

3-WAY Series
2.1 RECESSED
11) Turn the countertop around after the adhesive has hardened, using trestles for support.
12) Start to cut from the 30 mm hole in the centre of the washbasin, milling clockwise using a bit for contouring with an oversized nylon
bearing.
13) This will produce a finish with a straight edge.
14) To obtain a blunt finish, repeat the milling operation with a suitable milling bit for contouring.
15) Strengthen the inside of the join between the bowl and countertop using an excess piece of KRION™.
For a classic appearance, leave a slight rim from the sheet over
the bowl, as shown in the following diagram:
For a seamless monolithic appearance, try to conceal them as
much as possible.
To conceal any possible differences in tone between the sheets
and bowls, give the edge a 15º radius:
If this is not enough, give it a 30º radius:
2.1.2 WITH LOWER REBATE
In order to even further minimise any possible difference in tone between the bowl and countertop, an alternative installation to the
recessed method can be used to achieve this.
Advantage:
Better finish between the bowl and countertop.
Disadvantage:
Requires more time to prepare the sheet.
1) Place the KRION™ sheet face down on a working surface.
2) On the back of the countertop, use the bowl as a template and mark around its perimeter.
15º
30º
The change in angle must coincide with the seam between the bowl and countertop.
EN
Pág. 3/6