Introducing You Appliance; Installing Your New Appliance - Brandt BFL584YNW Guía De Instalación Y Uso

2. INTRODUCING YOU APPLIANCE

Installing your new appliance

Before using the appliance for the first
time, you should be informed of the
following tips.
Ventilation of appliance
In order to improve efficiency of
the cooling system and save energy, it is
necessary to maintain good ventilation
around the appliance for the dissipation
of heat. For this reason, sufficient clear
space should be available around the
refrigerator.
Suggestion: It is advisable for there to
be at least 75mm of space between the
back of the appliance and the wall, at
least 100mm from its top, at least 50mm
between its sides and the wall and a clear
space in front to allow the doors to open
at a 135°angle. As shown in the following
diagrams.
≥
100mm
≥ 75mm
Note:
This appliance performs well within
●
the climate class shown in the table
below.
It may not work properly if left at a
●
temperature above or below the indicated
range for a long period of time.
Climate class Ambient temperature
SN +10°C to +32°C
N +16°C to +32°C
ST +16°C to +38°C
T +16°C to +43°C
Place your appliance in a dry place to
●
avoid high moisture.
Keep the appliance out of direct
●
sunlight， rain or
appliance away from heat sources such
as stoves, fires or heaters.
Leveling of appliance
●
leveled, and the air to
correctly in the lower rear section of
the appliance, the bottom feet may
need to be adjusted. You can adjust
them manually by hand or by using a
suitable spanner.
●
the top backwards by about 10mm.
≤10mm
≥ 50mm ≥ 50mm
Installing the door handles
For the convenience of transportation,
the
provided in a plastic bag, you can
install the door handles as follows.
1025mm
1. Lever screw covers on the left side
of the door, and then put them back to
the plastic bag.
2. Match the handle on the left side of
the door, keeping axes of screw holes
in the handle and the door in a line, as
shown in the following picture.
3. Fix the handle with the special
screws provided in the plastic bag. And
then install the handle covers.
Note: Install the handle cover as
shown in the following picture. First
frost. Keep the
buckle
cover from the inside until you hear a
"popping" sound.
9
For the appliance to be sufficiently
To allow the doors to self-close, tilt
door handles are
1 2
the button, and then close the
circulate
separately