Installation Steps - GE GETP35-2 Guia De Instalacion

Installation Steps

Clean
mounting
surface
1
Mounting surface must be free
of dust, dirt or grease. Clean
mounting surface with alcohol
before installation and allow to dry.
If soldering is needed, refer to the steps 4a-6a
Silicone cover
4a
At the cut end, carefully peel
back the silicone cover over the
soldering pads. Make sure not to
remove the silicone over the LED.
If connector is needed, refer to the steps 4b-6b
Connector cover
Stopper
4b
Check the connector for
cosmetic issues. Open the
cover. Remove the stopper
from the tape guide.
Scissor mark
2
Measure and cut Tetra
tape to the desired length using
scissors. Cut only on the scissor
markings and stay within the
limit lines.
5a
Using UL certified 18AWG wire,
solder a red wire to the (+) pad
and a black wire to the (–) pad.
is open
Black
5b
Partially remove the tape
backing on the end to be
connected. Align red lead with
the (+) contact on the tape
and the black lead with the (-)
contact. Fully insert the tape into
the open end of the tape guide
with the LEDs facing the cover.
flexible
®
Black (–)
Red (+)
Red
+
–
Silicone
Tape
backing
3
Peel away a portion of the tape
backing at cut end. Press fit
an end cap fully to the open
end and apply electrical grade
silicone (see note below).
6a
Seal the soldering points with
electrical silicone. Replace the
silicone cover and secure it by
shrinking a piece of ¼" heat
shrink over the end.
"Click"
6b
Press the cover down onto
the tape guide until a "click"
is heard. Visually check
the connection for correct
polarity, good continuity, and
secureness.
End cap
Heat shrink