Anselmo Cola AFRODITE Manual De Instalación, Uso Y Mantenimiento página 46

Control rod in middle position - 2nd ref.
HOT AIR FLOW in
in upper direction
Position release
SLOT for inserting control
ROD and SELECTION lock
Position lock
The standard hot air ducting outlet is vertical; on customer request the outlet connection can be turned 90° or 180°
allowing the hot air to exit in the upper rear side or, with the addition of a flexible pipe, in the lower rear side or
towards to the floor.
Any modifications must be done by authorised and competent personnel; changes made at random can cause
serious damage to the stove, for which COLA declines any liability.
4.5 Optional probe and external thermostat
The standard unit controls the room temperature by means of a probe that adjusts the power according to the set
temperature. The probe is positioned in the remote control and measures the temperature in the place where the
remote control is located. The user can choose to use an external thermostat, connected directly to the
motherboard, whose sensor can be located in the most suitable place.
In case of an external thermostat, it is necessary to use a 'normally open' type. Contact an authorized technician
and follow the following instructions:
-
turn the unit off at the main switch and disconnect the power cable;
- remove the stove from the compartment and access the motherboard;
- referring to the wiring diagram, connect the two thermostat wires to the respective terminals TERM of the board;
-
refit everything, then set RADIO PROBE in menu 10;
frontal direction,
and in ducting
Control rod in middle position - 3rd ref.
HOT AIR FLOW in
in upper direction
46
frontal direction,
and in ducting
Control
ROD
4th
reference
3rd
reference
2nd
reference
1st
reference
AFRODITE