Worx VERSACUT WX420L Manual De Instrucciones página 16

Pocket /Plunge(Soft materials
only)
WARNING: DO NOT
bind the blade in the cut;
push the saw blade forward at a
rate where the blade is not
laboring.
When the cut is complete,
release the lock off switch and
let the blade come to a complete
stop. DO NOT REMOVE
the saw and blade from the
workpiece while the blade is
moving. This could damage
your cut (kerf), cause kickback
and loss of control, resulting in
injury.
Sawdust Removal
NOTE: If using the saw without
a vacuum attached, in some
circumstances after lengthy
operation, dust can accumulate
at the rear of the base and
prevent it from reaching full
depth. You can prevent this by
occasionally shaking the dust
out.
Fitting the plastic base plate
cover
16
WORKING HINTS FOR YOUR
TOOL
If your saw becomes too hot, please run your saw
no load for 2-3 minutes to cool the motor. Avoid
prolonged usage under strenuous cutting loads.
Protect saw blades against impact and shock.
Excessive feed significantly reduces the performance
capability of the machine and reduces the service life
of the saw blade. Sawing performance and cutting
quality depend essentially on the condition and the
tooth count of the saw blade. Therefore, use only
sharp saw blades that are suited for the material to
be worked.
Choice of blades: 24 teeth for general work, approx.
40 teeth for finer cuts, more than 40 teeth for very
fine cuts into delicate surfaces, diamond for tile,
cement board, etc.
MAINTAIN TOOLS WITH
CARE
Remove the plug from the socket before
carrying out any adjustment, servicing or
maintenance.
Keep tools sharp and clean for better and safer
performance. Follow instructions for lubricating and
Mini Circular Saw
changing accessories. Inspect tool cords periodically
and if damaged, have repaired by authorized service
facility. Your power tool requires no additional
lubrication or maintenance. There are no user
serviceable parts in your power tool. Never use water
or chemical cleaners to clean your power tool. Wipe
clean with a dry cloth. Always store your power tool
in a dry place. Keep the motor ventilation slots clean.
Keep all working controls free of dust.
See Fig. H1, H2
If the supply cord is damaged, it must be replaced
by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
Periodically clear dust and chips from guard and base
to ensure proper performance.
See Fig. I
See Fig. J
EN