Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Adding / Checking Engine Oil (See fig 8)
•
Place pressure washer on a level surface.
•
Remove one or both of the crankcase dipsticks to ensure you do not overfill the engine.
•
Carefully add 1.1 L (38 oz) of 4-Cycle engine oil (SAE10W30) to empty reservoir until oil reaches the outer edge of
the oil fill hole (Crankcase Dipstick hole).
•
Be sure to replace both dipsticks before attempting to start the engine.
•
To check oil, set pressure washer on a level surface, wipe dipstick clean, then reinsert dipstick without re-threading.
Adding Fuel (See fig 9)
•
Set pressure washer on a clean and level surface in an area that is well ventilated.
•
Remove fuel cap.
•
Insert a funnel into the fuel tank and carefully pour gasoline into the tank until fuel level reaches 1 1/2 inches below the
top of the neck.
CAUTION!
Oil must be added to unit prior to first use.
To avoid spillage, do not overfill fuel tank as gasoline expands.
CAUTION!
ASSEMBLY
FIG 8
FIG 9
14
Publicidad
Capítulos
Tabla de contenido
