Change The Direction Button; Start The Machine; Stop The Machine; Use The Brake - GreenWorks ZTF402 Manual Del Operario

4.2 CHANGE THE DIRECTION
BUTTON
Figure 4.
NOTE
The machine has a two-direction button.
1. Push the forward icon to go forward .
2. Push the backward icon to go backward.
WARNING
Move backward for short distance.
4.3

START THE MACHINE

Figure 4.
1. Set the power switch to the blue dot position.
2. Press the direction button.
3. Press the speed button.
4. Press the safety button.
IMPORTANT
If you do not rotate the throttole in 4 seconds, press the
safety button again.
5. Rotate the throttle.
4.4

STOP THE MACHINE

Figure 4.
1. Release the throttle.
2. Set the power switch to the red dot position.
WARNING
Do not let go of the handle until the machine does not
move.
WARNING
Put the machine on a level surface.
4.5

USE THE BRAKE

Figure 5.
4.5.1 LOCK THE BRAKE
1. Step on the brake.
4.5.2 UNLOCK THE BRAKE
1. Step on the brake again.
4.6

EMPTY THE BUCKET

Figure 6.
1. Stop the machine.
2. Push the bucket release lever to release the bucket.
English
3. Hold the bucket handle to lift the bucket.
4. Empty the bucket
5

MAINTENANCE

Before maintenance, make sure that you
• stop the machine.
• wait until all the moving parts stop.
• remove the battery pack from the machine.
Do not use strong solvents or detergents on the plastic
housing or components.
Do not let brake fluids, gasoline, petroleum-based materials
touch the plastic parts. Chemicals can cause damage to the
plastic, and make the plastic unserviceable.
5.1

CHANGE THE OIL

Change the oil each six months in the first year. Change the
oil each year in the remaining years.
5.1.1 EMPTY THE OIL
Figure 7.
1. Remove the drain plug with a wrench (not providded).
2. Drain the oil.
3. Install and tighten the drain plug.
5.1.2 ADD THE OIL
Figure 8.
1. Remove the oil plug with a wrench (not providded).
2. Add the oil into the oil hole.
3. Install and tighten the oil plug
The oil capacity is approximately 150 ml.
5.2

EXAMINE THE TIRE PRESSURE

Figure 6.
Keep the tire pressure between 28 and 30 psi.
5.2.1 ADD THE AIR
1. Remove the air cap.
2. Push the air hose (not provided) onto the valve stem.
5
WARNING
WARNING
WARNING
CAUTION
IMPORTANT
WARNING
EN