Power Information - Marq Ray Tracer X Quad Guia Del Usuario

Setup
Note: Items not listed under the Introduction > Box Contents are sold separately.

Power Information

Before connecting the fixture to a power outlet, make sure the power cable is not crimped or
damaged. Also, make sure the power outlet's voltage is within the range stated on this product (on
its housing or decal).
Before cleaning or replacing the fuse, disconnect Ray Tracer X Quad from its power source. Use
a screwdriver or other tool to remove the compartment (do not pull it out by the tab only). Replace
the fuse only with a new fuse with the same rating (250 V, 5 A).
Mounting/Rigging
Standing
Place the fixture on a flat, stable surface. Make sure all cables are secured and placed so that no one
will trip over them.
Suspended
Follow these steps to use the 1 2
hanging bracket (included) for
Clamp (not included)
mounting the fixture to a truss.
Hanging Bracket
3 4 5
(tighten until
secure)
1/4-turn
1/4-turn
5