SP BOX-600 INOX N Manual De Instalacion E Instrucciones De Uso página 11


Use screws and plugs, but first make sure that they are correct for the type of wall
where the hood is to be fitted.

Before setting Operations, remove the filter panels (Fig.4).

Drill 6 holes A-B-C of Φ 6, shown in (Fig.3).

Insert plugs and screws (Fig.3-A) without tightening completely, in such a manner that
the hood can be supported from them.
Then attach the Hood body to the wall using two internal screws. (Fig.3-C).

Fix the decorative telescopic support (Fig.5-1). Make sure all screws are tight.
Extraction version:

Using a joining pipe of diameter 150mm, connect output ring (Fig.5-3-A) and the
discharge opening. Secure the connection joints, to avoid air leaks, with self adhesive
tape.
Filter version:

If your installation does not have a discharge opening to the outside, you will have to
ask your supplier for active circular carbon filters, which are supplied as an
accessory and are not included as standard equipment. For mount them, see (Fig.6).

Fix in the wall the plastic bracket just below the decorative telescopic support (Fig.7).
The two pins of the support position have to fit with the holes of the plastic derivation.

You can easily cut the plastic shunt to fit well inside the top of the telescopic cover and
the air outlets are properly aligned with the exhaust grill. (Fig.8).

Using a joining pipe of diameter 150 mm, connect output ring and the plastic shunt.
Secure the connection joints to avoid the air leaks, with self adhesive tape. (Fig.10).
2.3.- Fitting the decorative telescopic cover

Turn the tab in the inside of the lower part of decorative telescope (Fig.5-2), this will
facilitate the fitting.

Fix the lower part of the decorative telescopic cover with hood body using inner screws
(Fig.5-3B).

Extend the top of the decorative telescopic cover and secure it to the upper support with
the two supplied screws. (Fig.5-1).
2.4.- GLASS FITTING (Only for ONDA CRISTAL model)

Carefully place the glass on the hood and attach to it by placing the 4 rubber pins (C)
and 4 screws (D) shown in (Fig.11).
11