Mounting On Single-Pos Stand; Mounting On Multi-Pos Holder - ACU-RITE DRO 100 Serie Instrucciones De Instalación

4 Mounting
4.1 Overview
This chapter contains all of the information necessary for
mounting the product.
The following steps are only to be performed
by qualified personnel.
Further information:
Page 7
4.2 Assembly
General mounting information
The receptacle for the mounting variants is provided on
the rear panel. The connection is compatible with VESA
standard 100 mm x 100 mm.
DRO 10x: Further information:
DRO 203, DRO 30x: Further information:
Page 36
The material for attaching the mounting variants on the
device is included in the delivery.
You will also need the following:
Torx T20 screwdriver
2.5 mm allen wrench
7 mm socket wrench
Material for mounting on supporting surface
The product must be mounted on a stand
or holder to ensure the correct and intended
operation of the product.
Routing the cables
In the figures showing the stand and holder,
you will find suggestions for routing the cables
after mounting.
Single-Pos stand: Further information:
Multi-Pos holder: Further information:
Mounting frame: Further information:
If mounting to a stand:
Bring the cables together
Route the cables together through the opening in the
stand from behind
Route the cables laterally to the connections
If mounting to a holder:
Bring the cables together
Route the cables laterally to the connections
Secure the cables to the arm with cable ties
10
"Personnel qualification",
"G", Page 35
"K",
"C", Page 4
"D", Page 4
"E", Page 4
ACU-RITE | DRO 100, DRO 203, DRO 300 | Installation Instructions | 01/2018
4.2.1

Mounting on Single-Pos stand

The Single-Pos stand allows you to place the product on
a surface at an inclination angle of 20° and secure the
product to a surface.
Mount the stand to the upper VESA 100 tapped holes on
the rear panel of the product
Use a Torx T20 screwdriver to tighten the countersunk
head screws M4 x 8 ISO 14581 included in delivery
Comply with the permissible tightening torque of 2.6
Nm
Secure the product against movement during operation
Attach the supplied self-adhesive rubber pads to the
bottom of the product
If you do not screw the product to a surface, attach
self-adhesive rubber pads to the bottom of the stand
Attach the rubber pads to the stand only if you
do not screw the product to a surface.
Further information: "C", Page 4
Dimensions of the Single-Pos stand
DRO 10x: Further information:
DRO 203, DRO 30x: Further information:
Page 37
4.2.2

Mounting on Multi-Pos holder

Mount the holder to the bottom VESA 100 tapped holes
on the rear panel of the product
Use a Torx T20 screwdriver to tighten the countersunk
head screws M4 x 10 ISO 14581 (black) included in
delivery
Comply with the permissible tightening torque of 2.5
Nm
You can tilt and swivel the holder to an angle that allows
you to comfortably view the readout.
Further information: "D", Page 4
Dimensions of the Multi-Pos holder
DRO 10x: Further information:
DRO 203, DRO 30x: Further information:
Page 37
"H", Page 35
"L",
"I", Page 36
"M",