Care & Cleaning
Turn off the water faucets after finishing the day's
washing. This will shut off the water supply to the
washer and prevent the unlikely possibility of damage
from escaping water.
Use a soft cloth to wipe up all detergent, bleach or
other spills as they occur.
Clean the following as recommended:
Control Panel – clean with a soft, damp cloth and
glass cleaner. Do not use abrasive powders or cleaning
pads.
Cabinet – clean with soap and water.
Fabric Softener Dispenser
1. Pull the dispenser off of the top of the agitator.
2. Soak for one hour in sink or container in
hot water and dishwashing liquid.
3. Hold hands over top and bottom of dispenser
and shake to loosen buildup.
4. Rinse with clean, hot water.
5. Repeat process if necessary.
6. Replace dispenser on agitator.
Do not use dishwashing liquid inside
the washer. Oversudsing can occur.
Storing the Washer
Washers can be damaged if water is not removed from
hoses and internal components before storage. Prepare
the washer for storage as follows:
• Select NORMAL on the REGULAR cycle and add
one cup of bleach OR white vinegar to a full load of
water without clothes. (Do not mix bleach and vine-
gar in the same wash. Hazardous fumes can form.)
Run the washer through a complete cycle.
• Turn the water faucets off and disconnect the inlet
hoses.
Interior – hard water deposits may be removed, if
needed, using a recommended cleaner labeled washer
safe.
The interior of the washer should be cleaned periodi-
cally to remove dirt, soil, odor or bacteria residue that
may remain in the washer as a result of washing
clothes. We recommend taking the following steps
every 60 to 120 days to clean and freshen your washer
interior. The frequency with which the washer should
be cleaned and freshened depends on factors such as
usage, the amount of dirt, soil or bacteria being run
through your washer, or the use of cold water.
To clean and freshen the washer interior:
1. Add a measured amount of chlorine bleach to
the bleach dispenser, following package
directions for a normal load.
2. Add 1/4 cup of detergent to the tub.
3. Run the washer through a complete cycle
using hot water and the Super water level
setting.
4. Repeat the process if necessary.
• Disconnect the washer from the electrical supply
and leave the washer lid open to let air circulate
inside the tub.
• If the washer has been stored in below-freezing
temperatures, allow time for the washer to thaw out
prior to use.
• After storage, select NORMAL on the REGULAR
cycle and run the washer through a complete cycle.
8