Cafe CSB42 Manual Del Propietário página 23

STEP 7 LEVEL REFRIGERATOR
All models have 4-point leveling. The front is
supported by leveling legs, the rear is supported by
adjustable wheels. Both are accessible from the front
of the refrigerator.
hex nut located above
the front wheels. Turn
clockwise to raise or
counterclockwise to lower
the refrigerator.
• For front leveling, use a
• Adjust height of refrigerator
to match installation cutout
cm). The refrigerator should be level and plumb with
cabinetry.
NOTICE: The rear leveling wheels and front leveling
(2.54 cm). If the installation requires more than
elevate the refrigerator on a sheet of plywood or
runners. Cabinetry trim could also be added across
the top of the opening to shorten the opening. If you
attempt to raise the refrigerator more than 1" (2.54
cm), you will damage the front leveling legs and
the rear leveling wheels. Make adjustments in
small increments.
STEP 8 ALTERNATE ANTI-TIP
PROCEDURE
The refrigerator must be secured to prevent
tipping.
• Raise the grille panel to access case trim.
holes through the metal top case trim.
22
Installation Instructions
STEP 8 ALTERNATE ANTI-TIP
PROCEDURE (Cont.)
metal clearance holes and into the wood soffit.
(1.91 cm) min. wood brace. The brace spanning the
enclosure must be securely fastened to cabinets on
both sides.
• Drill screws into adjacent cabinets through side case
trim.
STEP 9 ADJUST DOOR SWING
NOTE: This refrigerator has a 2-position door stop.
When space does not allow the door to swing open
fully to 115°, you may change the door swing to a
90° opening. The 130°, door swing option is not to be
if door opening is satisfactory for your installation
situation.
• Open the door to view the bottom hinge.
Note the door stop pin locations. The pin is factory
installed in the 115° position.
• Close the door.
From below,
use pliers to
Interior
unscrew the
door stop and
reinstall into the
90° position.
Hinge
Door Trim Pinch Point
WARNING
Hazard
Improper installation can lead to a finger pinch point
when operating the door, especially with children.
instructions for cabinet dimensions, trim assembly,
and door stop angle.
Skip this step
115° 130°
(Do not use
90°
for Stainless
Steel)
Door
49-1000081 Rev. 1