Care And Maintenance; After Use - Kobalt SGY-CMI Manual Del Usuario

OPERATING INSTRUCTIONS
Method 2:
a) Turn power to off ("O") position, disconnect
power cord.
b) Ensure drum is empty.
c) Positioned on side of mixer, grab front and
lift rear leg of mixer off the ground. Be careful
not to tip mixer on yourself.
d) Move mixer to desired location.
3. Cement mix instructions
Note: Refer to instructions from the cement mix manufacturer.
4. Pre-mixed cement mix instructions
Note: Refer to instructions from the pre-mix cement mix manufacturer.

CARE AND MAINTENANCE

AFTER USE: Clean out the drum with water. If cement has dried to the inside of mixer, tap the
outside of the drum with a rubber or plastic mallet. Dump mixer to empty dried cement from drum
(DO NOT use a steel hammer to dislodge dried cement from mixer).
Lightly grease all moving parts.
The gearbox is sealed for life. Do not attempt to open the gearbox and change the oil.This is not
necessary, and doing so will void the warranty. Keep the motor assembly clean and free of build
up. Wipe the on/off switch assembly and motor with a lightly dampened cloth. DO NOT spray water
directly onto motor. Protect motor assembly from rain. Store mixer indoors.
Please use caution when dumping the contents of the mixer. The motor should be in the OFF
position when emptying the mixer.
Method 2 METHOD 2
10
kobalttools.com