Mounting Instructions; Mounting Options - Feit Electric 73700 Guía De Uso Y Cuidado

Mounting Instructions

1
Carefully unpack and
unwrap fixture
Pole Mount:
1. Mount arm assembly (sold by others) in desired location firmly.
2. Feed supply wires up through mounting arm,
use wire nuts (CC) to connect neutral, line and
grounding wires (see step 4). Push the wires and
connectors into arm.
3. Tighten the 2 set screws on the fixture into the
mounting pole firmly.
CAUTION: TURN OFF THE CIRCUIT BREAKER AT
THE ELECTRICAL PANEL BEFORE INSTALLING THE
FIXTURE IN ORDER TO PREVENT POSSIBLE SHOCK.
3

Mounting Options

(Refer to page 7 for the wiring diagram)
Wall Mount:
1. Place the fixture end (shown below) onto
the wall at the desired location and mark
the position for the mounting screws. Drill
three holes as required. Either pilot holes
for the screw or holes for anchors. Install
the anchors as appropriate.
3. Install conduit fitting (not supplied) on the
fixture, feed the power supply wires into
the fixture / conduit fitting and connect with
fixture wires. Attach conduit into the fixture.
2
Installing the fixture
Check that black, white and ground wire are extending from the
fixture. Before wiring the fixture to the power supply, turn off
the electricity at the fuse or circuit breaker box. Fixture must be
grounded to avoid potential electric shock.
1.5" (38.1mm)
2.5" (63.5mm)
5
Please contact (562) 463-BULB for further assistance.
Para obtener asistencia en E.U.A. llame al (562) 463-BULB.
2. Take off the grommet.
4. Attach the fixture housing to the
wall as appropriate.
FEIT.COM