Gemini CDMP-7000 Manual De Instrucciones página 23

t r o u b l e s h o o t i n g
m i x e r
t r o u b l e s h o o t i n g
Low/ no oUTPUT
If the CDMP-7000 is not sending a loud signal or send-
ing no signal, check for the following possible reasons:
- Input selector is set incorrectly.
- The connections are set up improperly on the back
panel.
- Bad cable(s), improperly inserted cables, or loose con-
nection.
- Jacks or plugs are dirty, making a poor contact.
diSToRTed o UTP UT
If the CDMP-7000 is sending a distorted signal, check
for the following possible reasons:
- Master output level is too high.
- Input level (gain control) is too high.
digiTAL oUTPUT eR RoR
If the CDMP-7000's digital output is not performing,
check for the following possible reasons:
- The digital output sampling frequency of the CDMP-
7000 does not match the specifications of the con-
nected device.
- The digital output is being connected to an analog
input.
- The cable used to connect the digital output is not an
Optical S/PDIF cable.
23
- .
c d m p 7 0 0 0 m a n u a l • g e m i n i d j c o m