Lechange DB10 Guia De Incio Rapido página 6

f) Follow the App guide to connect your doorbell
FAQ
➢ How to restore default settings?
Please press Reset Button for 5s to restore default settings after completion, green
light will be on for 3s and then turn off ; the device will reboot automatically and
restore default settings.
➢ The device cannot work normally?
Please restore default settings of the device, and conflgure the device again.
➢ How to enter wireless configuration mode?
Please press Reset Button on the rear panel of the device,until the indicator light
turns to be green circular light, it means that hotspot has been enabled.
➢ The device is not online?
Please check the state of device indicator light. If red light flickers all the time, it
means that the device fails to connect the network.
Please check whether wireless router can access the Internet. To test it, you can
connect your smartphone to the same network, and check whether it can access
Internet.
➢ Connection is overtime?
a. The device, mobile phone and router are too far away please put them within
30cm (12 inches) when configuring.
b. Please reset the device to factory defaults and follow the guide on App page to try
again.
➢ The device cannot boot up?
3