Publicidad
Idiomas disponibles
Idiomas disponibles
LED Driver with constant output voltage for the operation of LED
(Electronic switch-type power supply unit)
TYPE: LMV10W12 UNI, LLV20W12 UNI, LMV10W24 UNI, LLV20W24 UNI
1 Technical Data:
Art. No.:
Constant output voltage
Rated voltage
Shared load operation
Open-circuit safety
Short circuit and overload protection
Ambient temperature ta
Housing temperature tc-point
EMC conformity
Primary cable
Secondary cable
2. Installation Instructions
The installation may only be carried out by an electrical specialist in accordance with international and
national standards.
The LED Driver is strictly suited for the use with LED that require a constant voltage of VDC
according to the values in the table.
When connecting the LED, careful attention should be paid to connecting + and – to the right
terminals on the LED Driver.
When working on electrical systems, the protection against electric shock is to be ensured by disconnecting
the system.
Instal primary and secondary mains intersection-free (RFI protection)
LED Drivers mounted outside of luminaires are to be screwed tightly to the respective surface by their screw
holes and careful attention is to be paid to the primary and secondary cables being fastened securely in the
strain relief.
The tc temperature may not be exceeded for any kind of mounting. The devices do not contain any
serviceable components and may not be opened.
3. Important Information
Our LED Drivers are surge-voltage-stable with values above those prescribed by the respective standards.
As a protection against high voltage surges, as they occur e.g. when switching fluorescent lamps and
discharge lamps with an inductive ballast, motors (fans, etc.) and other inductive charges, the load circuits
for devices of this kind are to be clearly separated from each other.
!!The LED Driver cannot be regulated via a phase cut-on or cut-off dimmer!!
4. Safety Functions
In case of a short circuit or overload the LED Driver will automatically cut off. It does not have a fuse of the
conventional kind. Thus the load circuit is not separated!
As soon as the defect has been repaired, the LED Driver will automatically cut back in.
5. Heat Dissipation and Heat Transfer
Operation in excess ambient temperature or through external heating will reduce the service life. During the
installation process ( particularly into luminaires ), heat dissipation ( heat transfer ) is to be provided through
suitable measures. The ambient temperature and/or tc temperature may not be exceeded at any time. We
are not liable for damage resulting from improper use.
Description and Mounting Instructions
LMV10W12 UNI
12VDC SELV equivalent
0-10W
Electronic disconnection with automatic restart
Max.70°C
EN 61547, EN 55015, EN 61000-3-2, EN 61000-3-3
Min. H03VV-F 2x0,75mm² for strain relief
Min. H03VV-F 2x0,75mm² for strain relief
Protection class 2
LLV20W12 UNI
LMV10W24 UNI
24VDC SELV equivalent
100-240V~ 50-60Hz
0-20W
0-10W
guaranteed
-20°C - +50°C
Max.75°C
Max.70°C
CE
LLV20W24 UNI
0-20W
Max.75°C
Publicidad
