Publicidad
Idiomas disponibles
Idiomas disponibles
Installation Instructions - NFFLD-S/UFLD-S
Wire Guard Installation
Tools Required
Phillips head screwdriver, Flat head screwdriver.
WARNING
Make certain power is OFF before starting installation or
attempting any maintenance.
1.
Make certain all power is OFF before starting
installation.
2.
Remove the existing (4) black clips on the edge of the
lens with flat head screwdriver. (Figure 6.)
3.
Insert the accessory spacers over existing holes.
4.
Align wire guard on top of accessory spacers matching
the (4) existing holes. (Figure 7 .)
5.
Add (4) 10-24 Philips head screws to the face of the
fixture to tighten the wire guard.
6.
To remove wire guard follow steps 1-4 in reverse order.
Figure 6.
4
EATON
IB506003EN
Flat Head Screwdriver
Installation instructions
(4) Accessory
Spacers
(4) Screws
Figure 7.
Vandal Shield Installation
Tools Required
Phillips head screw driver, Flat head screwdriver.
WARNING
Make certain power is OFF before starting installation or
attempting any maintenance.
1.
Make certain all power is OFF before starting
installation.
2.
Remove the existing (4) black clips on the edge of the
lens with flat head screwdriver. (Figure 6.)
3.
Align the (4) 7/8" standoffs on top of the (4) accessory
spacers.
4.
Use (4) 10-24 x 1-1/2" screws to secure vandal shield
on top of fixture. (Figure 8.)
5.
To remove vandal shield follow steps 1-4 in reverse
order.
(4) Accessory
Spacers
Figure 8.
Wire Guard
(4) Stand Offs
Vandal Shield
Publicidad
