Bestway FLOWCLEAR 58401E Manual De Instrucciones página 14

Filter:
This function is used to filter pool water and should be
positioned here 99% of the time. Water is pumped through the
sand filter, where it is cleaned and returned to the pool.
A
Backwash:
bed; water is pumped down through the Collector Hub,
upwards through the sand bed, and deposited out of Port D.
A
Drain:
This function drains water from the pool; another filter
bypass setting, water is pumped and deposited out of Port D, instead
of returning it to the pool.
A
NOTE:
• Be sure all provisions for wastewater disposal meet applicable local, state or national codes. Do not discharge water where it will cause flooding or
damage.
• When the Control Valve is set to the Backwash, Rinse, or Drain position, water will discharge from Port D on the Control Valve.
• Do not switch on or operate the sand filter with the Control Valve set to the Closed function or it will seriously damage the sand filter.
• Do not set the Control Valve between two functions, or it will lead to leaking.
• To avoid water leakage, screw the Port D Cap onto the Control Valve Port D before operating the filter or circulate function.
Air Release
Press down the control valve handle and wait untill the water flow from Port D to release the air.
NOTE:
It is important to repeat this operation every time you start the pump after winterizing, maintenance and backwashing the sand bed.
FIRST TIME USE INSTRUCTIONS
Backwash and Rinsing must be performed to prepare the pump for its first use and to wash the sand.
CAUTION: DO NOT DRY RUN THE SAND FILTER
1. Press down on the Control Valve handle and rotate to the Backwash function.
2. Plug in and run the sand filter for 3-5 minutes, or until the water runs clear.
3. Switch off the sand filter and set the Control Valve to the Rinse function.
4. Switch on the sand filter and run the sand filter for 1 min. This circulates water backwards through the sand filter and drains water out Port D.
5. Switch off the sand filter. Set the Control Valve to the Closed function.
6. Top up pool water if required.
IMPORTANT:
Switch off the sand filter immediately if water levels near the pool's Inlet and Outlet valves.
P-S-005168/21.0x28.5cm/58401E/客专1000gal 砂滤器说明书/JS-YF-2017-B-01008-英
C
B
This function is used to clean the sand
C
D
B
C
D
B
This procedure removes water from the pool, which you'll need to replace.
Closed:
This function stops water flowing between the sand
filter and the pool.
A
Rinse:
This function for initial startup, cleaning, and sand bed
leveling after Backwash; water is pumped downwards through
the sand bed, up through the Collector Hub and deposited out
of the valve Port D.
A
Circulate:
This function circulates pool water bypassing
the sand filter; use this function if the filter is broken to collect
debris in the Debris Screens.
A
Backwash
14
C
B
C
D
B
C
B
Rinsing
P-S-005168