Install the Lavatory (cont.)
Use a soft lead pencil to mark the location of the mounting slots
on the wall. The slots are located on the underside of the lavatory.
Also, trace the base outline of the lavatory onto the cabinet top.
Remove the lavatory.
Drill a 1/8" hole at each of the locations marked on the wall.
Apply a bead of adhesive sealant on the inside edge of the line
traced on the cabinet top.
Carefully position the lavatory, aligning the mounting slots with
the drilled holes.
From underneath the lavatory, secure the lavatory to the wall
with washers and lag screws placed through the mounting slots.
Do not overtighten the screws.
Remove any excess sealant.
Apply a bead of adhesive sealant between the lavatory and the
wall, and between the cabinet and the wall.
Connect the P-trap and water supplies to the lavatory.
Turn on the water supplies and check for leaks. Repair as
required.
1007273-2-B
6
Kohler Co.