Technical Characteristics - Comelit 100.20002611 Manual Tecnico

WARNING
• Install the equipment by carefully following the instructions given by the manufacturer and in compliance with the standards in
force.
• All the equipment must only be used for the purpose it was designed for. SCAME Parre S.p.A. does not assume responsibility
for improper use of the apparatus, for modifications made by third parties for any reason or purpose, or for the use of non-original
accessories and materials.
• All the products comply with the requirements of Directive 2006/95/EC (which replaces Directive 73/23/EEC and subsequent
amendments), as certified by the CE mark they carry.
• Installation, mounting and assistance procedures for electrical devices must only be performed by specialised electricians.
• Cut off the power supply before carrying out any maintenance work.
• Clean using a damp cloth. Do not use alcohol or other aggressive products.
The programming interface 100.20002611 allows you to connect a PC loaded with programming software to
the OPERA system to be programmed. The module is equipped with a micro USB output port, so a connection
cable with a standard USB connector at one end and a micro USB connector at the other is required.

TECHNICAL CHARACTERISTICS

Power supply voltage
Consumption
USB side transmission speed
BUS side transmission speed
USB side connector
BUS side connector
Approvals
Operating temperature
Storage temperature
Relative air humidity
Indications
Weight
Dimensions
• Specifications are subject to change without notice.
• SimpleProg software is required to program OPERA automation devices; this software can be downloaded from the website
www.scame.com
ART. 100.20002611 - OPERA/MICRO USB INTERFACE
24Vdc ±%
10 mA
19200 bps
2400 bps
Type B micro USB female connector
terminal block*
CE
0° to 40°C INDOOR USE
-10° to +70°C
5 to 95% with no condensation
Flashing yellow LED:
data transmission on BUS;
Steady yellow LED:
power supply negative absent or
incorrect connection of device;
Red LED:
possible collision of messages on BUS.
70g
42 x 42 x 18 mm (1 DIN module)
*TERMINAL BLOCK
-
Power supply negative
+
+24 Vdc power supply
D
Data BUS
3