Publicidad
Idiomas disponibles
Idiomas disponibles
Gas outlet extractor.
Ceramic fiber joint (replace).
Nuts and washers (5 units).
Exhaust circuit extractor.
Ceramic fiber joint (replace).
Back convection chamber plate.
Front convection chamber plate.
When reassembling the exhaust it is COMPULSORY to replace the exhaust joint with a new one as you run
the risk of gas entering in our home.
5.10. Dismantling and Cleaning of gas outlet pipes.
When mounting the gas outlet pipeline, make sure it is well assembled, preferably sealed with silicone. If the
pipe has sealing joints, you must verify its good condition and replace it if necessary.
5.11. Lubrication of the brass tips of the endless shaft's upper and lower parts with lubricant oil; a small quantity is
enough for all the season.
You get access to the lower tip from inside the hopper, you will see it clearly after removing all pellets.
In order to reach the upper tip, you have to dismantle the endless screw from the back side of the stove; this
shall be necessary only in case of noise as it has been lubricated at manufacturing, with a high quality
lubricant sufficient for many years.
Reducing motor of endless.
Brass fitting and lubrication point.
5.12. Cleaning of the pellets drop tube.
Use the brush provided by BIO+ to remove the dust until the end of the tube.
32
Drawing 14
Drawing 15
Drawing 16
Publicidad
