Passbands; Set Clock; Delete Data - Megger Ducter DLRO-10 Guia Del Usuario

General Operation - DLRO 10X

Passbands

This option allows you to set upper and lower limits between
which the test result average must fall if it is to be signalled as a
Pass (a long tone from the buzzer). Readings outside these
limits will be signalled as a Fail (a short tone from the buzzer).
Values are entered via the keypad complete with decimal points,
where applicable, and including µ or m (See section on the
Alphanumeric Keypad). It is not necessary to enter the Ω symbol.
The upper limit must be less than or equal to 2000.0 Ω and the
lower limit must be less than the upper limit.
After completing the upper limit press Enter. DLRO 10X will
check that valid numbers have been entered and will move to the
lower limit. Complete this limit and press Enter. DLRO 10X will
check that valid numbers have been entered and will display the
option to ENABLE or DISABLE the passbands.
Highlight your choice and press Enter. You will return to the Main
Menu screen.
Note: Passbands will remain enabled or disabled until you enter
this screen and change the selection. If all that is required is to
change Passbands from ENABLED to DISABLE or vice versa,
enter the PASSBAND screen and press Enter until the
ENABLED / DISABLED choice is shown at which time you may
change the selection.

Set Clock

This option sets the real time clock date and time settings as well
as setting the date format. When you enter this screen the
current date, time and date format will be displayed.
Use the cursor control Up and Down arrows to adjust the
highlighted data. Step to the next item by using the Right cursor
control arrow.
The row below DD MM YY HH MM contains respectively the
date, the month, the two-digit year, the hour of the day in 24-hour
notation and the minute. These must be entered in this sequence
regardless of the date format you wish to use.
TEST OPTIONS RANGE
NORM AUTO
DD MM YY HH MM
09/10/00 15.08
DD MM YY
09/10/00 12.02
The bottom line shows the current setting of date and time. This
is updated when you press Enter to exit the Set Clock function.
However, tests already stored prior to changing the date format
will retain the old format.

Delete Data

Select Delete Data if you wish to clear DLRO 10X's memory of
stored data. In case you have selected this Option by accident
you will be asked to confirm that you wish to delete the data; the
default is NO. Change this to YES and press Enter if you wish to
delete all data.
Please note - ALL stored data will be deleted.
The lower DD/MM/YY
shows the current date
format. Pressing the
cursor control Up
arrow will cycle through
the available options
DD/MM/YY, MM/DD/YY or
YY/MM/DD.
9