Samson Stage XPD1 Guia De Inicio Rapido página 4

Stage XPD1 Controls
1. Status Indicator - This LED displays the operation mode:
Amber
Flashing Amber Pairing/Low Battery
2. Power/Pair Switch - Press <5 seconds to turn the unit on or off.
Press >5 seconds to enter pairing mode.
3. Battery Cover - Unscrew the battery cover and slide down to
open the HXD1 battery compartment.
4. Battery Holder - Open the battery holder by pressing the tab
and lifting the cover. Insert two standard AA (LR6) batteries
here, being sure to observe the plus and minus polarity mark-
ings shown. Although rechargeable Ni-Cad batteries can be
used, they do not supply adequate current for more than four
hours.
WARNING: Do not insert the batteries backwards; doing so
can cause severe damage to the HXD1 and will void your war-
ranty.
5. Input GAIN Control - This control adjusts the transmitter input
sensitivity. This input sensitivity control has been factory pre-
set to provide optimum level for the particular microphone
capsule provided with the Stage XPD1 system and so we
recommend that this not be adjusted manually. If necessary,
however, you can use the supplied plastic screwdriver to raise
or lower the input level.
6. USB Connector - Plugs into the USB jack on the rear panel of a
wirelessly enabled Samson audio device. The receiver can also
plug directly into a computer USB port and will be recognized
as a USB audio device. The unit passes audio to the device
and receives power from the device through this connector.
7. PAIR Switch - Press >5 seconds to enter pairing mode.
8. STATUS Indicator - This LED displays the operation mode:
Amber
Flashing Amber Pairing
No Light
Normal Operation
Normal Operation
Not Paired; Transmitter Out Of Range;
No Power
8
7
6