Submersible Pump; Safety Measures - Makita PF 0300 Manual De Instrucciones

Submersible Pump

GB

1. Safety measures

Carefully read the operating instructions before assembling
and starting. The appliance must not be used by persons
who are not thoroughly acquainted with the instructions
handbook (operating instructions). Children and persons
under the age of 16 cannot use the pump and must be kept
well away from the appliance when it is connected.
The user is liable towards third parties in the area where
the appliance is in operation.
This appliance is not intended for use by persons
(including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction
concerning use of the appliance by a person responsible
for their safety.
Children should be supervised to ensure that they do not
play with the appliance.
While the pump is operating persons
must not be in the liquid to be pumped.
The pump may be connected only by
means of a safety switch for fault currents, with
a rated opening current up to 30 mA and a socket
with an earth contact installed in conformity with
the regulations.
Protection: at least 10 A
Operation in swimming pools and garden ponds is
admitted.
For other operation, the provisions in conformity with
the standard VDE 0100 part 702 must be respected.
CAUTION: Before checking, connect the pump and
the system with no voltage!
Replacing the line connecting up with the mains
requires using special tools and therefore may be done
only by the manufacturer or its service engineers.
The pump may operate only with a pipe connecting the
appliance (extension) that is no lighter than a rubber
hose mod. H07 RNF in conformity with the DIN 57282
or DIN 57245 standard.
(For your safety)
The voltage (120 Volts alternating current)
indicated on the pump's rating plate must
correspond to the available mains voltage.
Before starting it is necessary to make sure by having a
check made by qualified personnel that there are the
necessary electrical protection measures.
• Earth connection.
• Earthed neutral.
• The safety switch for fault currents corresponds to the
safety regulations of the electricity board and functions
perfectly.
ENGLISH
• Plug connections must be protected from water. If there
is a risk of flooding, plug connections must be placed
somewhere safe.
• Definitely avoid pumping aggressive liquids and abrasive
products.
In the event of the pump failing, repair work may only
be carried out by the repair workshops of the technical
service. Only genuine spare parts must be used.
It is notified that in conformity with the law on product
liability
we cannot be held responsible
for the damage caused by our appliance:
a) because of improper repairs not carried out by the
personnel of the assistance points authorized by us;
b) or if GENUINE SPARE PARTS are not used to replace
parts;
c) or if the indications and provisions given in the
instructions handbook are not complied with.
The same provisions hold for the accessories.
Resistance
The maximum temperature of the delivery liquid should
never exceed +35°C in continuous operation.
Inflammable, combustible or explosive liquids cannot
be conveyed with this pump!
In particular, do not use engine fuels, detergents, or other
chemical products.
2. Use
CAUTION! Sector of use
"DRAINAGE" – To transfer and empty fresh to
slightly polluted water from rainwater barrels and
casks.
"VORTEX" –
for discharge and waste water with solids in
suspension.
Also used as emergency pump, in case of
overflowing with muddy water, thanks to its large
suction filter.
To achieve excellent motor cooling the pump
casing is provided with a breather hole that enables
water to flow out.
The pump must be protected from running dry.
Starting
First put the pump into water and then
connect the plug.
The pump is ready for use.
Note: pollution of liquid could occur due to leakage of lubricant.
2
(Original instructions)
Portable submersible pump