California Safe Drinking Water And Toxic Enforcement Act; Proper Installation - General Electric 234D1754P002 Manual Del Propietário

ADDITIONAL GAS DRYER WARNINGS
For your safety, the information in this manual must be followed to minimize the risk of fire or explosion
WARNING
or to prevent damage, personal injury, or death.
- DO NOT store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.
- WHAT TO DO IF YOU SMELL GAS:
-

California Safe Drinking Water and Toxic Enforcement Act

This act requires the governor of California to publish a list of substances known to the state to cause cancer, birth defects or other
reproductive harm and requires businesses to warn customers of potential exposure to such substances.
Gas appliances can cause minor exposure to four of these substances, namely benzene, carbon monoxide, formaldehyde and
soot, caused primarily by the incomplete combustion of natural gas or LP fuels.
Properly adjusted dryers will minimize incomplete combustion. Exposure to these substances can be minimized further by properly
venting the dryer to the outdoors.

PROPER INSTALLATION

This dryer must be properly installed and located in accordance with the Installation Instructions before it is used.
If you did not receive an Installation Instructions, you can receive one by visiting GEAppliances.com or by calling
800.GE.CARES (800.432.2737).
Properly ground dryer to conform with all governing codes
and ordinances. Follow details in Installation Instructions.
Install or store where it will not be exposed to temperatures
below freezing or exposed to the weather.
Connect to a properly rated, protected and sized power
supply circuit to avoid electrical overload.
Remove all sharp packing items and dispose of all shipping
materials properly.
Remove the colored protective tape from the control panel.
Do not obstruct the flow of ventilating air. Do not stack or
place laundry or throw rugs against the front or back of the
dryer.
Steam Water Hoses:
GE strongly recommends the use of factory specified parts.
A list of factory hoses available for purchase are listed
below. These hoses are manufactured and tested to meet
GE specifications.
GE strongly recommends the use of new water supply
hoses. Hoses degrade over time and need to be replaced
every 5 years to reduce the risk of hose failures and water
damage.
Parts and Accessories
Order on-line at GEApplianceparts.com today, 24 hours a
day or by phone at 800.626.2002 during normal business
hours.
Part Number Accessory
WE25M53 Complete Kit (hoses, Y-adapter
washers) (included)
OR
WE1M847 Long Hose and
WE1M849 Short Hose
PM14X10056 Dryer door opening vent brush
(not included)
WX14X10007 LintEater™ Dryer rotary tube brush
(not included)
DR07X10002 6' Cable
DRM2E300V0 ACM, Splitter, two 6' Cables & a 1' Cable
Exhaust/Ducting:
All dryers MUST be exhausted to the outside to prevent
1
large amounts of moisture and lint from being blown into
the room.
Use only rigid metal 4 diameter ductwork inside the dryer
2
cabinet and use only rigid metal 4 diameter or UL
approved transition ducting between the dryer and the
home duct. USE OF PLASTIC OR OTHER COMBUSTIBLE
DUCTWORK CAN CAUSE A FIRE. PUNCTURED DUCTWORK
CAN CAUSE A FIRE IF IT COLLAPSES OR BECOMES
OTHERWISE RESTRICTED IN USE OR DURING
INSTALLATION.
For complete details, follow the Installation Instructions.
SAVE THESE INSTRUCTIONS
GEAppliances.com
3