Publicidad
Idiomas disponibles
Idiomas disponibles
l
L~~~~~L
OPTIONAL ACCESSORIES
O Sequential Trip Mechanism Ki
(Shingle Shot Parts)
O Pneumatic Tool Lubricant
.8 oz. (25 cc) oil feeder
4 oz. (120 cc) oil feeder
1 quart (1 Itr) can
NOTE:
... sold separately
(Code No. 876762)
(Code N0.8771 53)
(Code N0.874042)
(Code N0.87621 2)
Aocessories are subject to change without any
obligation on the part of HITACHl.
APPLICATIO~IS
o
o
o
o
o
Floor and wa[1 framing.
Truss build-up, Window bui[d-up.
Subflooring and roof decking.
Wall sheathing.
Mobile home and modu[ar housing construction.
BEFORE
O PERATION
Read section titied "SAFETY" (Pa9es 4 - 6).
Make sure ot the touowings before operation.
WORKING ENVIRON~IENT
1 . Power source
O Use only clean, dry, regulated compressed air as a power
source for this Nailer.
O Air compressors used to supply compressed air to this
Nailer must comply with the requirements of the latest
version of ANSI Standard B 1 9.3 "Safety Standard For
Compressors For Process Industries."
O Moisture or oil in the air compressor may accelerate wear
and corrosion in the Nailer.
Drain daily.
2. Filter-Regulator-Lubricator
O Use a regulator with a pressure range of O - 120 psi
(O - 8.3 bar O - 8.5 kgf/cm2).
O Filter-regulator-lubricator units supply an optimum
condition for the Nailer and extend the Nailer life.
These units shou[d always be used.
Filter .............. The filter removes moisture and dirt mixed
in compressed air.
Drain daily unless fitted with an automatic
drain.
Keep the filter clean by regular
maintenance.
Regulator ....... The regulator controls the operating
pressure for safe operation of the Nailer.
Inspect the regulator before operation to be
sure it operates properiy.
Lubricator ...... The lubricator supplies an oil mist to the
Nailer.
Inspect the lubricator before operation to be
sure the supply of lubricant is adequate.
Use Hitachi pneumatic too[ :ubricant.
AIR
No flammable gas, Iiquid or other flammable
objects at worksite.
Clear the area of children or unauthorized personnel.
SUPPLY
O Never use oxygen, combustible gases or any other
bottled gases.
O Never connect Nailer to pressure which potentially
exceeds 200 psi (13.7 bar 14kgf/cm2).
O Never use non relieving coupler on Naiter.
3.
4.
o
~-
Nailer Side
Regulator
Compressor Side
Filter
Lubricator
Air hose
Air hose must have a minimum working pressure rating of
1 50 psi (1 0.4 bar i0.6 kgf/cm2) or 150'/¥ of the maximum
pressure produced in the system, whichever is higher.
HoSe coupling
The Nailer can be installed as follows:
Remove the dust seal placed at the air inlet.
Install a 3/8 NPT male plug at the air inlet.
~$r
Dust Cap
~
~c
~ 3/8 NPT Male plug
O A femaie coupler must be on the air hose.
The hose coupling (male plug-female coupler) must remove
all pressure from the Nailer when disconnected.
Never use a non relieving coupler on the Nailer.
-9-
Publicidad
