Maintenance - Greenlee PVA0021 Manual De Instrucciones

Maintenance

Wear eye protection when operating
or servicing this tool.
Failure to wear eye protection could
result in serious eye injury from
flying debris or hydraulic oil.
Do not change accessories, inspect, adjust or
clean valve when it is connected to a power source.
Accidental start-up can result in serious injury.
Failure to observe this warning could result in severe
injury or death.
Greenlee / A Textron Company
Use this maintenance schedule to maximize the tool's
service life.
Notes: Keep decals clean and legible. Replace when
necessary — see the decals in the Parts List.
When disposing of any components (hydraulic hoses,
hydraulic fluid, worn parts, etc.), do so in accordance
with federal, state and local laws or ordinances.
Daily
1. Wipe all tool surfaces clean.
2. Inspect the hydraulic hoses and fittings for signs
of leaks, cracks, wear or damage. Replace if
necessary.
3. Install dust caps when the tool is disconnected.
Monthly
1. Perform a thorough inspection of the hydrau-
lic hoses and fittings as instructed in publication
99930323, SAE J1273 (Hose and Hose Assemblies).
2. Check the pressure to the tool by installing an in-line
pressure gauge, rated for 700 bar (10,000 psi),
between the valve and the tool.
Annually
If required by your organization, have the tool inspected
by an authorized Greenlee Utility service center.
10
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
PVA0021 • PVA0022