Custom-Cut Baffle Adjustment - Scag Power Equipment SWZ Serie Manual Del Operador

Custom-Cut Baffle Adjustment

The Custom-Cut Baffle is designed to deliver optimum
airflow and superior cutting performance in any type of
grass. The Custom-Cut Baffle can be raised or lowered
to precisely tailor the deck's performance for the type of
grass being cut. The baffle can be set in three (3)
different positions for optimum performance.
A. 3" Position - baffle is installed using the top set of
holes on the front baffle welded inside the cutter
deck. (See Figure 9). The Velocity-Plus and
Advantage cutter decks will deliver the best quality-
of-cut in very tall, wiry, tough to cut grass.
B. 3-1/2" Position (factory setting for Advantage cutter
decks) - baffle is installed using the middle set of
holes on the front baffle welded inside the cutter
deck. (See Figure 10). For general purpose cutting,
place the Custom Cut Baffle in the 3-1/2" position.
This gives the best mix of cutting performance in all
types of grass.
C. 4" Position (factory setting for Velocity-Plus cutter
decks) - baffle is installed using the bottom set of
holes on the front baffle welded inside the cutter
deck. (See Figure 11). Placing the baffle in the 4"
setting will enhance fall cutting (leaf pickup) and
reduce cutter deck "blowout".
To Adjust the Custom-Cut Baffle height:
1. Remove the hardware securing the Custom-Cut Baffle
to the cutter deck (See Figure 8).
-NOTE-
Hardware location used in the illustrations are for
reference only. Location of hardware may vary
depending on the cutter deck size.
MOUNTING
HARDWARE
Figure 8. Custom-Cut Baffle
2. Move the Custom-Cut Baffle to desired position. (See
3. Reinstall the mounting hardware as shown. (See Figures
MOUNTING
HARDWARE
2004 CCB
12
Figures 9 through 11 for position).
9 though 11). Torque hardware to 39ft.lbs.
TOP SET OF HOLES
FOR 3" SETTING
Figure 9. 3" Custom-Cut Baffle Position
MIDDLE SET OF HOLES
FOR 3-1/2" SETTING
Figure 10. 3-1/2" Custom-Cut Baffle Position
BOTTOM SET OF HOLES
FOR 4" SETTING
Figure 11. 4" Custom-Cut Baffle Position
CARRIAGE BOLT
2004 CCB - 3" Setting
ELASTIC STOP
NUT
CARRIAGE BOLT
2004 CCB - 3-1/2" Setting
ELASTIC STOP
NUT
CARRIAGE BOLT
2004 CCB - 4" Setting
ELASTIC STOP
NUT