Publicidad
Idiomas disponibles
Idiomas disponibles
How to Stop Your Pressure
Washer
•
Move control lever to "Stop" position.
•
Squeeze trigger
on the spray gun to relieve
pressure
in the hose.
NOTE: A small amount of water will squirt out when
you release the pressure.
How To Use the Adjustable
Nozzle
You now should know how to START your pressure
washer and how to STOP it. The information in this
section will tell you how to adjust the spray pattern
and apply detergent or other cleaning chemicals.
_
DANGER!
Never adjust spray pattern when
spraying. Never put hands in front of nozzle to
adjust spray pattern.
On the end of your spray gun is a nozzle handle that
can adjust the spray pressure and the spray pattern.
•
Point the nozzle toward the ground, disengage the
safety latch, and press the trigger to test the
pattern.
Sliding the nozzle forward and back adjusts the
spray pressure.
Slide nozzle backward for
Slide nozzle forward for low
high pressure mode.
pressure mode and
detergent application.
Twisting the nozzle adjusts the spray pattern from
a narrow pattern to a fan pattern.
Twist nozzle counter-
clockwise for fan pattern.
Twist nozzle clockwise for
narrow spray pattern.
•
For most effective cleaning, keep the spray nozzle
between 8 to 24 inches away from cleaning
surface.
•
If you get the spray nozzle too close, especially
using high pressure mode, you may damage the
surface being cleaned.
•
Do Not get closer than 8 inches when cleaning
tires.
Applying
Detergent with Adjustable
Nozzle
IMPORTANT: Use chemicals designed specifically for
pressure washers. Household detergents could
damage the pump.
IMPORTANT: You must attach all hoses before you
start the engine. Starting the engine without all the
hoses connected and without the water turned ON will
damage the pump.
To apply detergent, follow these steps:
•
Review the use of the adjustable nozzle.
•
Prepare the detergent solution as required by the
job.
•
Hang the detergent solution container on the hook
attached to the handle.
•
Place the filter end of the detergent siphoning tube
into the detergent container.
_
AUTION:
When inserting the filter into the
detergent container, route the tube so as to
keep it from inadvertently contacting the hot
muffler.
•
Slide the adjustable nozzle forward to low pressure
mode. Detergent cannot be applied with the nozzle
in high pressure position.
Publicidad
