Wiring Instructions - Code 3 Gemineye CC7008-WK Instrucciones De Instalación

Notes:
1. Larger wires and tight connections will provide longer service life for components. For high current wires it is recommended
that terminal blocks or soldered connections be used with shrink tubing to protect the connections. Do not use insulation
displacement connectors (e.g., 3M Scotchlock type connectors)
2. Route wiring using grommets and sealant when passing through compartment walls. Minimize the number of splices to
reduce voltage drop. High ambient temperatures (e.g., under-hood) will significantly reduce the current carrying capacity of
wires, fuses, and circuit breakers. All wiring should conform to the minimum wire size and other recommendations of the
manufacturer and be protected from moving parts and hot surfaces. Looms, grommets, cable ties, and similar installation
hardware should be used to anchor and protect all wiring.
3. Fuses or circuit breakers should be located as close to the power takeoff points as possible and properly sized to protect the
wiring and devices.
4. Particular attention should be paid to the location and method of making electrical connections and splices to protect these
points from corrosion and loss of conductivity.
5. Ground termination should be only be made to substantial chassis components, preferably directly to the vehicle battery.
6. Circuit breakers are very sensitive to high temperatures and will "false trip" when mounted in hot enviroments or operated
close to their capacity.
CAMERA MODEL CC2027-WC
INSTALLATION AND MOUNTING:
Important! Mount the camera at a location that provides the best view of the area immediately behind the vehicle. Generally, mounting locations toward the
top of the vehicle provide the best field of view. Lower mounting locations reduce the field of view and increase the likelihood of damage from road spray.
Carefully remove the unit from its packaging. Examine the unit for transit damage. If damage is found, return the product to your local dealer for war-
ranty replacement. Do not use damaged or broken parts.
U-BRACKET CAMERA MOUNTING INSTRUCTIONS:
1. Select a level surface for installation.
2. Drill mounting holes using the lower U-bracket as a template and attach the U-bracket with user supplied hardware.
3. Install the camera and sun-visor on the U-bracket as shown in Figure 1.
4. Adjust the camera's position for the best viewing angle before tightening the two screws on each end.
5. Attach the antenna such that it is vertical.

WIRING INSTRUCTIONS:

Important! Waterproof all connections whether inside or outside the vehicle by using sealant and wrapping with insulation tape. Wrap tape tightly,
overlapping by one-half widths so there are no gaps.
The unit is designed or electrical systems from 12 to 24VDC (10 to 30VDC extremes).
The wiring for all systems is:
Red Wire Positive (+)
Black Wire Negative (-)
All wiring should be a minimum of 20 AWG. A 3-amp fuse in the positive
line is required (see Figure 3).
Figure 1
For reference only
Figure 2
3
Figure 3
Page 2 of 11