Publicidad
Idiomas disponibles
Idiomas disponibles
4.2 Programming the Appliance
PROG
"BATT" fl ashes when
the battery has run out
4.2.1 Programming the Litre Information
•
Briefl y press the "PROG" button
"PRG" fl ashes in the display
fi lter system manual.)
Note: Press the "PROG" button
changes.
•
Press the "RESET" button
fl ashes in the display
•
Press the "RESET" button
display
.
8
•
Press the "PROG" button
fl ashes.
•
Repeat the steps above until the litre information determined has been entered.
•
Press the "PROG" button
programming mode. The "PRG" fi eld in the display
•
The litre information entered is shown in the display
missioned.
4.3 Installation of the Sensor
Note: During installation, pay attention to the direction of fl ow.
•
Close the water inlet.
•
If a fi lter system is already installed, remove the inlet hose
nut.
•
Tighten the union nut
seal
.
6
•
Tighten the inlet hose
Caution: The max. tightening torque at the 3/4" connections must not exceed
!
15 Nm!
4.4 Installation of the Display Unit
The display unit can be attached to the desired position with double-sided adhesive tape
or a screw (neither included in the delivery scope).
Caution: There must not be any water pipes or electrical cables behind the mounting
!
surface. Do not lay the connecting cable parallel to cables conducting electricity because
this can lead to an impairment of the sensor signal.
10
RESET
PROG
"PRG" fl ashes when the
programming mode is
activated
, the display changes to the programming mode,
7
. (How to identify the fi lter capacity is described in the
8
again to leave programming without making any
7
to jump to the litre information. The relevant number
9
.
8
until the desired number is shown fl ashing in the
9
to reach the next digit to be entered. The relevant digit
7
to confi rm the litre information entered and to leave the
7
of the sensor
5
on the sensor
4
RESET
"1,2,3,4,5" fl ashes during
"Memory Call-Up" and
represents the memory level
no longer fl ashes.
8
, the system can now be com-
8
on the fi lter head. If necessary, insert a fl at
1
.
2
PROG
RESET
that is being called up
by loosening the union
4
Publicidad
