Toto GO TLG01201U Manual De Instalación Y Del Propietario página 5

6. Orient the spout as needed. From
below the mounting surface, place
the crescent shaped gasket and
washer over the mounting stud as
shown.
Fasten the mounting nut to the stud
to secure the spout.
Tighten with wrench as needed.
7. Connect each hose to
the side port of each valve.
Tighten with wrench.
NOTE: If wrapping
the hose(s) in a loop is
needed, be careful not
to crimp the hose at any
point at this could restrict
the water flow.
Handles
8. Orient handle assembly and
lower onto the exposed portion of
valve until engaged.Fasten handle
escutcheon to collar with provided set
screw.
Repeat for other handle assembly.
NOTE: If handles do not line up
exactly as desired, remove handle
from valve and reinstall one (1) notch
over (on valve). Fine adjustment may
be done by slightly rotating valve
from underneath installed surface.
INSTALLATION PROCEDURE
Mounting
Stud
5
Washer
Spring
Washer
Mounting
Nut
Hose
Gasket
Set Screw
Handle
Assembly
Valve