Accessories; Optional Parts - Fujitsu AIRSTAGE ARXD07GALH Manual De Instalación

Tool name
Pressure is huge and cannot be measured with a
conventional (R22) gauge. To prevent erroneous mixing
of other refrigerants, the diameter of each port has been
Gauge manifold changed.
It is recommended to use a gauge manifold with a high
pressure display range –0.1 to 5.3 MPa and a low pressure
display range –0.1 to 3.8 MPa.
To increase pressure resistance, the hose material and base
Charging hose
size were changed.
A conventional (R22) vacuum pump can be used by installing
a vacuum pump adapter.
Vacuum pump Be sure that the pump oil does not backflow into the system.
Use one capable for vacuum suction of –100.7 kPa (5 Torr,
–755 mmHg).
Gas leakage detector Special gas leakage detector for HFC refrigerant R410A.

2.3. Accessories

For installation purposes, be sure to use the parts supplied by the manufacturer or
other prescribed parts.
The use of non-prescribed parts can cause serious accidents such as the unit to fall,
water leakage, electric shock, or fi re.
The following installation parts are furnished. Use them as required.
Keep the Installation Manual in a safe place and do not discard any other accessories
until the installation work has been completed.
Do not discard any accessories needed for installation until the installation work has
been completed.
Name and Shape
Operating Manual
Installation Manual
Installation template
Washer
Coupler heat insulation (Large)
Coupler heat insulation (Small)
9374342273-01_IM.indb Sec1:2 9374342273-01_IM.indb Sec1:2
Contents of change
WARNING
Q'ty Application
1
(This book)
1
For positioning the indoor unit
1
For installing indoor unit
8
For indoor side pipe joint (Large pipe)
1
For indoor side pipe joint (Small pipe)
1
Name and Shape Q'ty
Cable tie (Medium)
2
Cable tie (Large)
4
Filter (Small)
2
(AR07/09/
12/14/24)
Filter (Big)
2 (AR18)
1 (AR24)
Drain hose
1
Hose band
1
Drain hose insulation B
1

2.4. Optional parts

Description Model No.
IR receiver unit UTB-*WC
Remote sensor UTD-RS100
External output wire 9379529013
External input wire D 9368779016
External input wire F 9368779023
External input wire B 9368778002
External input wire E 9368778019
Auto louver grille UTD-G*S*-W
Application
For transmission and remote controller
cable binding
For fixing the coupler heat insulation.
For installing drain pipe VP25
(O.D.32, I.D.25)
For installing drain hose
Insulates the drain hose
Application
For the wireless remote
controller.
Room temperature sensor
For output port
For control input port
(Apply voltage terminal)
For control input port
(Dry contact terminal)
For forced thermostat off port
(Apply voltage terminal)
For forced thermostat off
port (Dry contact terminal)
For Auto louver grille
En-2
7/12/2012 10:18:57 AM 7/12/2012 10:18:57 AM