Sunbeam STEAM MASTER LX Manual De Instrucciones página 6

SHOT OF STEAM FEATURE
The
S S
OF
HOT TEAM
l
wrinkles. The
S
HOT
is at least i/4 full of water and the temperature dial is set within the steam band.
Allow the iron to heat for approximately two minutes.
l
Press the white
S
l
Pump
S
OF
HOT
l
The ' @ feature is now ready for use. The
l
just a short pause between shots. The
in a horizontal position just above the fabric being ironed.
If the tank runs dry, unplug the iron and refill with water. The iron may be filled with water
l
while it is hot. N
OTE
feature again.
S S
HOT OF TEAM
SPRAY MIST FEATURE
(Some Models On/y)
Use the Spray Misp feature to dampen fabrics with stubborn wrinkles.
l
Press the gray Spray Mist button firmly to produce spray.
l
SAFETY SMART FEATURE AUTO SHUT-OFF
(Some Models On/y)
When the iron is plugged into 120 volt AC electrical outlet, the steady red light signals that
l
the iron is plugged in and is ready to be turned on.
If the iron is left on the heel rest unmoved the iron will stop heating in 15 minutes.
l
The light on the handle will blink to indicate the iron has automatically shut off
and will continue blinking until the iron is restarted or unplugged.
If the iron is left unmoved in the ironing position or accidentally tipped over, the iron will stop
l
heating in 30 seconds. Again, the light on the handle will blink to indicate the iron
has automatically shut off and will continue blinking until the iron is restarted
or unplugged.
N : If the temperature dial is turned to the Off position, the light will continue blinking
OTE
l
and then go off.
To restart the iron, move the iron back and forth. Allow the iron to heat and continue ironing
l
as normal.
N : Although heat is no longer generated once the iron has automatically shut off,
OTE
l
allow sufficient time for the iron to cool before touching the soleplate or storing the iron.
feature provides an extra burst of steam for deep penetration of stubborn
OF
button several times to prime the pump.
S @
OF
HOT TEAM
button another three to four times in order to clean the unit.
: It may be necessary to re-prime the pump before using the
S
OF
HOT
feature is most effective with the iron held
S S '
OF
HOT TEAM
feature can be used continuously with