Publicidad
Idiomas disponibles
Idiomas disponibles
Look for decay and rot. If the trunk is
rotted, it can snap and fall toward the
operator. Check for broken or dead
branches
which can fall on you while
cutting.
Make sure there is enough
room for the tree to fall. Maintain a dis-
tance of 2-1/2tree lengths from the near-
est person or other objects. Engine
noise can drown out a warning call.
Remove dirt, stones,
loose bark, nails,
staples, and wire from the tree where
cuts are to be made.
Plan a clear retreat path to the rear
and diagonal to the line of fall.
_
Plan a clear retreat path
....
{_,..._--'_
- Direction of Fall
45 ° /
y/e,&"
FELLING
LARGE TREES
(6 inches (15 cm) in diameter or larger)
The notch method is used to fell large
trees.
A notch is cut on the side of the
tree in the desired direction
of fall. After
a felling cut is made on the opposite
side of tree, the tree will tend to fall into
the notch.
NOTE:
If the tree has large
buttress
roots, remove
them before making the
notch.
If using saw to remove buttress
roots, keep saw chain from contacting
ground to prevent dulling of the chain.
NOTCH CUT AND FELLING
THE
TREE
• Make notch cut by cutting the top of
the notch first. Cut through t/3 of the
diameter
of the tree. Next complete
the notch by cutting the bottom of the
notch. See illustration.
Once the
notch is cut remove the notch of
wood from the tree.
Final (felling) cut here, 2 inches
(5 era) above center of notch.
r
--
First out
,'i
I/
:÷I/
i:
I
• After removing the wood from the
notch, make the felling cut on the op-
posite side of the notch. This is done
by making a cut about two inches (5
cm) higher than the center of the
notch. This will leave enough uncut
wood between the felling cut and the
notch to form a hinge. This hinge will
help prevent the tree from falling in the
wrong direction.
Hinge holds tree on stump and helps
control fall
Opening
of felling
Closing of
notch
NOTE:
Before felling
cut is complete,
use wedges to open the cut if necessary
to control the direction
of fall. To avoid
kickback and chain damage,
use wood
or plastic wedges,
but never steel or iron
wedges.
• Be alert to signs that the tree is
ready to fall: cracking sounds,
widen-
ing of the felling cut, or movement
in
the upper branches.
• As tree starts to fall, stop saw, put it
down, and get away quickly on your
planned retreat path.
• DO NOT cut down a partially fallen tree
with your saw. Be extremely cautious
with partially fallen trees that may be
poorly supported. When a tree doesn't
fall completely, set the saw aside and
pull down the tree with a cable winch,
block and tackle, or tractor.
CUTTING
A FALLEN TREE
(BUCKING)
Bucking is tile term used for cutting a
fallen tree to the desired log size.
&WARNING:
Do not stand on the
log being cut. Any portion can roll
causing loss of footing and control. Do
not stand downhill
of the log being cut.
IMPORTANT
POINTS
• Cut only one log at a time.
• Cut shattered wood very carefully;
sharp pieces of wood could be flung
toward operator.
• Use a sawhorse
to cut small logs.
Never allow another person to hold
the log while cutting and never hold
the log with your leg or foot.
11
Publicidad
