Introduction And General Description; Controls, Indicators And Connectors; Kate Controls; Spencer Controls - MANOSTAT VARISTALTIC KATE 72-620-000 Manual Del Usuario

The MANOSTAT VARISTALTIC dispensers and pumps provide dispensing or continuous pumping of fluids while power
is supplied.
The speed range for the KATE and SPENCER pumps is 24–720 rpm. 115 V pumps are UL and cUL listed. 230 V pumps
are CE certified.
Model No.
72-620-000 KATE, Analog Dispenser, 115 V
72-620-230 KATE, Analog Dispenser, 230 V
72-640-000 SPENCER, Analog Dispenser, 115 V
72-640-230 SPENCER, Analog Dispenser, 230 V

KATE CONTROLS

A. POWER (ON/OFF) SWITCH: Turns the unit ON or OFF. Glows green when power is ON.
B. FLOW SPEED CONTROL KNOB: Sets the speed of the pump. The higher the number on the dial, the faster the
speed of the pump.
C. FLOW TIME CONTROL KNOB: Sets the time needed to dispense aliquot from 2 to 20 seconds.
D. FRONT PANEL/REMOTE SWITCH: Sets operation from either the front panel controls or remote operation.
E. MANUAL/TIMED DISPENSE SWITCH: Sets the dispensing mode when Footswitch (part no. 73-750-000) or
Dispenser Wand (part no. 73-055-590) is depressed.
F. MODE SWITCH: DISPENSER/CONTINUOUS PUMP: Sets the unit for Dispensing or Pumping.
G. RUN STATUS JACK: Located on the rear panel of the units. The jack contacts are rated for 24 V at 1 A. These
contacts can operate remote relays to start or stop other equipment being utilized in conjunction with the dispens-
ers. Pump contacts are normally open when the pump is not running and closed when the pump is running. A
3.5 mm stereo plug (part no. B-3968, not included with the pump) can be ordered for easy access to the pump
status jack contacts.

SPENCER CONTROLS

A. POWER (ON/OFF) SWITCH: Turns the unit ON or OFF. Glows green when power is ON.
B. FLOW SPEED CONTROL KNOB: Sets the speed of the pump. The higher the number on the dial, the faster the
speed of the pump.
C. MODE SET KNOB: Sets one of four modes of operation: Continuous Pump, Manual Dispense, Timed Single
Dispense and Timed Repeated Dispense.
D. FLOW TIME CONTROL KNOB: Sets the time needed to dispense aliquot from 2 to 20 seconds.
E. FRONT PANEL/REMOTE SWITCH: Sets operation from either the front panel controls or remote operation.

INTRODUCTION AND GENERAL DESCRIPTION

Description

CONTROLS, INDICATORS AND CONNECTORS

Figure 1.
5